User guide

net
-l0
Sends an Ethernet loopback to a specified destination node. You specify the
address of the destination node with the -da option.
-l1
Requests a MOP loopback.
-rb
Requests to be rebooted by sending a MOP V4 request boot message to a remote
boot node. You specify the address of the destination node with the -da option.
-csr
Displays the values of the Ethernet port CSRs.
-els
Enables the extended design verification test (DVT) loop service.
-kls
Kills the extended DVT loop service.
-cm mode_string
Changes the mode of the port device. The mode string can be one of the following
abbreviations:
nm Normal mode
in Internal loopback
ex External loopback
nf Normal filter
pr Promiscuous
mc Multicast
ip Internal loopback and promiscuous
fc Force collisions
nofc Do not force collisions
df Default
-da node_address
Specifies the address of a destination node to be used with the -l0, -id,or-rb
option.
-l file_name
Broadcasts a MOP load request that requests the specified load file.
Console Commands 13–73