User guide

Table 10–16 (Cont.) VME_IF_BASE +

A8 VIC_BTDR Block transfer deﬁnition register

AC VIC_ICR Interface conﬁguration register

B0 VIC_ARCR Arbiter/requester conﬁguration register

B4 VIC_AMSR Address modiﬁer source register

B8 VIC_BESR Bus error status register

BC VIC_DMASR DMA status register

C0 VIC_SS0CR0 Slave select 0/control register 0

The D32 enable must be set in VIC_SS0CR0.

C4 VIC_SS0CR1 Slave select 0/control register 1

C8 VIC_SS1CR0 Slave select 1/control register 0

CC VIC_SS1CR1 Slave select 1/control register 1

D0 VIC_RCR Release control register

D4 VIC_BTCR Block transfer control register

D8 VIC_BTLR1 Block transfer length register 1

DC VIC_BTLR0 Block transfer length register 0

E0 VIC_SRR System reset register

E4 BTLR2 Block transfer length register 2

E8-FC Reserved locations

100 VIP_CR VME interface processor control register

104 VIP_BESR VME interface processor bus error/status register

108 VIP_ICR VME interface processor interrupt control register

10C VIP_IRR VME interface processor interrupt reason register

110 VIP_HWIPL VME interface processor hardware IPL mask register

114 VIP_DIAG CSR VME interface processor diagnostic register

118 VIP_PMCSR VME interface processor page monitor CSR

11C VIP_OBISGABR VME interface processor outbound internal scatter-gather

entry ABR

120 VIP_OBISGMSK VME interface processor outbound internal scatter-gather

entry mask

124 VIP_OBISGWORD VME interface processor outbound internal scatter-gather

entry control word

(continued on next page)

10–38 VME Interface