User`s manual

8. Observe the debug monitor messages that immediately follow when the
Alpha PCI 64–275 is turned on. These messages describe your system
configuration, version dates, and memory size, and conclude with the
AlphaPC64> system prompt.
9. Verify the memory size and system configuration information displayed.
10. If you do not see the debug monitor messages, turn off the power to the
Alpha PCI 64–275. Verify that the previous steps were performed correctly,
verify the seating of the memory SIMMs, and check that all the jumpers
are in their default positions. Then repeat steps 6 through 8.
The Alpha PCI 64–275 is ready to be used. Refer to the Alpha Microprocessors
Debug Monitor User’s Guide for a complete list of commands.
4.2 Board Jumpers
Figure 2 shows the location of the jumpers on the motherboard. Figure 3
shows the J3 jumper positions in detail. Table 2 and Table 3 describe what the
various jumper positions signify.
6