User`s manual

4.4 Returning from Windows NT ARC Firmware to the Debug Monitor
You may use either of the following two methods to return to the debug monitor
from the Windows NT ARC Firmware:
• Turn off the power to the Alpha PCI 64–275, remove the jumper from J3-25
(SP7 on the module), and then turn on the power to the Alpha PCI 64–275.
• Use the Windows NT ARC Firmware menus to choose the debug monitor,
as follows:
1. At the Boot menu, choose Supplementary menu....
2. At the Supplementary menu, choose Setup the system....
3. At the Setup the system menu, choose Machine specific setup....
4. At the Machine specific setup menu, choose Debug Monitor.
5. Turn off the power to the Alpha PCI 64–275, then turn the power back
on.
15