Specifications

3. Ensure the exhaust system is operating.

4. Set flow control valve so flow indicator reads be-

tween 40 and 45 liters per minute. (Check regu-

lator to ensure 20 psi pressure).

5. Switch power switch to “ON”.

6. Depress run button. Controller will automatically

step the program through the various steps out-

lined earlier.

7. When the program has ended, the controller will

maintain the chamber temperature at a value

equal to the last programmed level (PL) until the

program is cancelled. It will not automatically

cool to ambient unless last programmed level

(PL) is set at ambient. When a program is can-

celled the controller will maintain the chamber

temperature at a value equal to the main set

point (SP1 or SP). To cancel a program depress

and release the “UP” and “DOWN” push buttons

simultaneously. Be sure single set point mode is

set to 20 degrees as described earlier in this

manual.

8. At the end of the program, turn the flow control

valve fully clockwise to the closed position.

INSTALLATION AND OPERATION OF AIR CONTROL