Specifications

Set Ramp Rates

1. With the programmer not operating, indicated by

the bottom right hand side of the display extin-

guished, depress scroll button until PR1 is dis-

played. Push the up or down button to scroll to

the desired value, which is degrees per minute.

Scrolling down below zero will give three other options for

the ramp:

NONE-which will force the program to skip to

the next segment;

END-which will cause the program to stop or re-

start if loops remaining is not zero;

STEP-which will cause the program to ramp as

quickly as possible to the next temperature

level.

All other ramps in the program are set in a similar fashion

by selecting ‘PR’ followed by the relevant ramp number.

Set Level Temperatures

2. The level to which the first ramp is aiming is

entered by scrolling through the main scroll list

until “PL1” is displayed. By pressing either the

up or down button the present value of this level

is indicated in display units. Using the up or

down button will scroll the present value to the

new value required. All other levels in the pro-

gram are set in a similar fashion by selecting

‘PL’ followed by the relevant number.

Set Dwell Times

3. To set the dwell time for the first level, scroll

through the main scroll list until “Pd1” is dis-

played. Pressing the up or down button will

reveal the current value of time in minutes.

Using the up or down button will scroll the pres-

ent value to the new value required. Scrolling

this value downscale will allow a setting of

“END.” A setting of “END” will terminate the pro-

gram, or force it to restart if loops remaining are

not zero at the beginning of that dwell.

MULTI-PROGRAMMABLE MODELS