Specifications

Temperature Controller
This controller provides accurate control at one single
temperature setting. To set temperature, simply:
1. Turn Power switch ON.
2. While depressing the Push To Set Temperature
button, turn the temperature knob until you
reach the desired set point temperature as indi-
cated on digital display.
3. Release the Push To Set Temperature button.
The digital display will now indicate the actual chamber
temperature. The furnace will heat to the new set point
temperature. The CYCLE light will remain on until the fur-
nace temperature is within 1°C of the set point tempera-
ture; then the CYCLE light will turn on and off as the con-
troller maintains the set point temperature.
Sensor Break Protection
This controller provides sensor break protection in the
event the thermocouple opens. If an open thermocouple
condition occurs, the digital display will indicate 5 degrees
or less and the power to the heating element will be shut
off (CYCLE light will extinguish).
14
BASIC AUTOMATIC TEMPERATURE CONTROL OPERATION
Note
If at any time the Temperature
Adjustment knob is turned in either
direction, the set point will change,
even if the Push To Set Temperature
button is not depressed. To view the
current set point temperature, depress
the Push To Set Temperature button.