User's Manual

DIGITAL CONTROL INCORPORATED
DigiTrak Falcon

F2

Operator’s Manual 11
Audible Tones
The Falcon F2 receiver beeps to signal power on/off, confirm menu
changes, and acknowledge the pass/fail status of actions. The
receiver also beeps with transmitter temperature increases.
Transmitter Temperature
Warning Tones
Page 60
Two long beeps indicate a problem with the menu option selected and a failure screen will
appear until you click the trigger or remove the battery (in the case of a critical failure). Verify
your setup and try the operation again or contact DCI Customer Service for assistance.
Startup Screen
Insert a charged battery pack. To power on the receiver, click the trigger. After you have read
the warning screen, click again to acknowledge you have read and understand this manual.
The receiver displays the startup screen, which includes the results of several startup tests:
Receiver Startup Screen
Click to exit the startup screen. The Falcon F2 receiver proceeds to the
Locate screen.
Locate Screen
Page 29
Note If an item of the self-test fails, a "Fail" warning displays on the startup
screen instead of "Pass". If the error is not addressed in this manual,
please contact DCI Customer Service.
Adjusting Screen Contrast
To make the screen lighter or darker, hold the trigger while on the locate
screen with the receiver held vertical. Release the trigger when the screen
contrast reaches the desired level.
Customer service
phone numbers
Regional designation
number must match
that of transmitter
Receiver ID number
Software version