User's Manual

DIGITAL CONTROL INCORPORATED

4 DigiTrak Falcon



Operator’s Manual

General Transmitter Care Instructions

Periodically clean the spring and threads inside the battery compartment as well as the spring

and threads of the battery end cap to ensure a proper power connection with the batteries.

Use an emery cloth or wire brush to remove any oxidation that has built up. Be careful not to

damage the battery cap O-ring; remove it while cleaning if necessary. After cleaning, use a

conductive lubricant on the battery cap threads to keep it from binding in the battery

compartment.

Note For better battery performance, all DCI battery-powered transmitters ship

with both a special battery contact spring and a nickel-based anti-seize

lubricant on the battery end cap to aid in electrical contact.

Before use, inspect the battery cap O-ring for damage that may allow water to enter the

battery compartment. Replace the O-ring if the one installed becomes damaged.

Do not use chemicals to clean the transmitter.

Placing tape around the fiberglass tube of the transmitter, if space allows, will keep the

fiberglass protected from most corrosive and abrasive environmental wear.

Falcon transmitters have a threaded hole (1/4”-20 thread) in the battery cap to allow the use

of an insertion/extraction tool for installing and removing the transmitters in end-load

housings. Ensure that this hole remains clear of debris.

Send in the Product Registration Card or register online at access.DigiTrak.com for the

90-day Limited Warranty.