User's Manual

DIGITAL CONTROL INCORPORATED
30 DigiTrak Falcon
™
F5

Operator’s Manual
So I Just Paired, Now What?
After pairing, the receiver proceeds to the calibration screen as a
reminder that with the selection of a new frequency band, the
transmitter and receiver need to be calibrated. Install the transmitter in
the drill head and calibrate.
Prior to calibration, "Calibration required" is indicated on the Locate
screen by an error symbol in the roll indicator in place of the roll value.
To change between bands mid-bore, both bands must be separately
selected and calibrated prior to drilling.
Calibration
Page 16
Calibration Required
Before or during drilling, switch between bands any time if interference
is compromising the current band.
Changing Frequency Bands
Page 69
After pairing optimized frequency bands, for typical operations your
next steps before drilling would be:
 calibrate
 check Above Ground Range
 check for background Interference
Complete each of these checks on both optimized frequency bands.
Above Ground Range (AGR)
Page 19
Interference
Page 43
Transmitter Selection
Use this option to select between a Falcon F5, Falcon F2, or DucTrak transmitter, as well as
select the other band on your current transmitter.
Transmitter Selection Menu
After you select a different transmitter than is currently in use, the display returns to the
previous screen.