User's Manual

DIGITAL CONTROL INCORPORATED
DigiTrak Falcon
™
F5

Operator’s Manual 11
Toggle and Trigger Switches
The Falcon F5 receiver has two switches for operating the system: a toggle switch located on
the top of the unit and a trigger located under the handle.
Toggle Switch Use to access and navigate menus.
Trigger Switch Use to turn on the receiver, select (click on) menu options, and
change the screen view for depth readings. Pull and release
(click) once, hold briefly and release, or use in combination with
the toggle switch, depending on the desired action.
Audible Tones
The Falcon F5 receiver beeps to signal power on/off, confirm menu
changes, and acknowledge the pass/fail status of actions. The
receiver also beeps with transmitter temperature increases.
Transmitter Temperature
Warning Tones
Page 68
Two long beeps indicate a problem with the menu option selected and a failure screen will
appear until you click the trigger or remove the battery (in the case of a critical failure). Verify
your setup and try the operation again or contact DCI Customer Service for assistance.
Startup Screen
Insert a charged battery pack. To power on the receiver, click the trigger. After you have read
the warning screen, click again to acknowledge you have read and understand this manual.
The receiver displays the startup screen:
Receiver Startup Screen
Click to exit the startup screen and open the Main menu.
Receiver Menus
Page 14
Note If an item of the self-test fails, a warning displays and a failure
message appears in place of the system name. Please contact DCI
Customer Service.
Calibration
Page 16
Customer service
phone numbers
Regional designation
number must match
that of transmitter
Receiver ID number
Software version