User's Manual
Table Of Contents
- Operator’s Manual
- Digital
- Control
- Incorporated
- DCI Headquarters 19625 62nd Ave. S., Suite B-103 Kent, Washington 98032 USA Tel 425 251 0559 / 800 288 3610 Fax 253 395 2800 E-mail DCI@digital-control.com www.digitrak.com
- Important Notice
- Safety Precautions and Warnings
- Safety Precautions and Warnings (Continued)
- _
- Introduction
- _
- Receiver
- Power On
- Toggle and Trigger Switches
- Speaker and Audible Tones
- Adjusting Screen Contrast
- Main Menu
- Locate Menu
- Set US Menu
- Low Fre/High Fre Menu
- Configure Menu
- Changing the Telemetry Channel
- 1-Point Calibration
- 2-Point Calibration (In-ground Calibration)
- Changing the Grade Mode
- Changing the Depth Measurement Mode
- Cold Screen / Normal Screen
- Tele Option A/B
- Locator DL / No Locator DL (Enabling and Disabling DataLog Menus)
- Set Roll / Unset Roll (Enabling and Disabling Roll Offset Function)
- Remote Display
- _
- Transmitter
- _
- Battery Charger
- _
- Locating
- _
- The Target Steering® Function
- _
- Cable System
- Cable System Components
- Non-DCI Supplies Required for Operating the Cable System
- Connecting Power Supply to Power Source and Cable Transmitter
- Grounding the Cable Transmitter
- Cable Transmitter On/Off
- Calibrating the Cable Transmitter
- Enabling the Roll Offset Function on the Remote Display
- Locating Using the Cable System
- Viewing Transmitter Depth or Predicted Depth
- Viewing Status of Cable System Power Source
- Target Steering Function Using the Cable System
- Troubleshooting
- _
- Appendix
- Depth Increase in Inches (Centimeters) per 6-foot (1.8 meter) Rod
- Depth Increase in Inches (Centimeters) per 10-foot (3-meter) Rod
- Depth Increase in Inches (Centimeters) per 15-foot (4.6-meter) Rod
- Percent of Grade to Degree Conversions (0.1% Pitch Transmitters or Sensitive Pitch)
- Degree to Percent of Grade Conversions (0.1% Pitch Transmitters)
- Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
DIGITAL CONTROL INCORPORATED
Locating
The graphic display on the Eclipse receiver uses icons to show readings and system status information.
The locate mode screen provides real-time data about the transmitter’s temperature, frequency mode,
pitch, roll, and signal strength, in addition to displaying the channel setting.
SH
7.5
%
CH:B1
411
75
°
F
Pitch
Clock/Roll
Frequency
Mode
Transmitter
Temperature
Pitch/Roll
Update
Indicator
Channel
Setting
Signal
Strength
Locate Mode Screen
The depth mode screen (trigger held in) provides the same real-time data given on the locate mode
screen and also displays the ultrasonic height setting, the transmitter’s depth, and battery status
information for both the receiver and the transmitter. The “lock in” symbol (the letter “R”) appears when
you hold in the trigger to “lock in” on the reference signal at a locate point.
15.8
SH
7.5
%
CH:B1
75
°
F
456.5
R
Ultrasonic
Setting
Receiver
Battery Status
Depth of
Transmitter
Signal “Lock in”
Reference Symbol
Receiver Battery
Voltage Remaining
Transmitter Battery
Status (shown full)
Depth Display Screen
DigiTrak
®
Eclipse
®
Operator’s Manual 47