User's Manual
Table Of Contents
- Operator’s Manual
- Digital
- Control
- Incorporated
- DCI Headquarters 19625 62nd Ave. S., Suite B-103 Kent, Washington 98032 USA Tel 425 251 0559 / 800 288 3610 Fax 253 395 2800 E-mail DCI@digital-control.com www.digitrak.com
- Important Notice
- Safety Precautions and Warnings
- Safety Precautions and Warnings (Continued)
- _
- Introduction
- _
- Receiver
- Power On
- Toggle and Trigger Switches
- Speaker and Audible Tones
- Adjusting Screen Contrast
- Main Menu
- Locate Menu
- Set US Menu
- Low Fre/High Fre Menu
- Configure Menu
- Changing the Telemetry Channel
- 1-Point Calibration
- 2-Point Calibration (In-ground Calibration)
- Changing the Grade Mode
- Changing the Depth Measurement Mode
- Cold Screen / Normal Screen
- Tele Option A/B
- Locator DL / No Locator DL (Enabling and Disabling DataLog Menus)
- Set Roll / Unset Roll (Enabling and Disabling Roll Offset Function)
- Remote Display
- _
- Transmitter
- _
- Battery Charger
- _
- Locating
- _
- The Target Steering® Function
- _
- Cable System
- Cable System Components
- Non-DCI Supplies Required for Operating the Cable System
- Connecting Power Supply to Power Source and Cable Transmitter
- Grounding the Cable Transmitter
- Cable Transmitter On/Off
- Calibrating the Cable Transmitter
- Enabling the Roll Offset Function on the Remote Display
- Locating Using the Cable System
- Viewing Transmitter Depth or Predicted Depth
- Viewing Status of Cable System Power Source
- Target Steering Function Using the Cable System
- Troubleshooting
- _
- Appendix
- Depth Increase in Inches (Centimeters) per 6-foot (1.8 meter) Rod
- Depth Increase in Inches (Centimeters) per 10-foot (3-meter) Rod
- Depth Increase in Inches (Centimeters) per 15-foot (4.6-meter) Rod
- Percent of Grade to Degree Conversions (0.1% Pitch Transmitters or Sensitive Pitch)
- Degree to Percent of Grade Conversions (0.1% Pitch Transmitters)
- Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
When the remote display is in remote mode (receiving data from the receiver), you will see the letters
“RO” for roll offset underneath the clock, indicating that a compensation for the transmitter’s roll position
has occurred.
-1.5
%
CH:B1
75
°
F
RO
Eclipse Remote Display with Roll Offset Displayed
Removing Roll Offset Number
If you want to change the roll offset, you must first remove the “old” roll offset number. The instructions to
remove the roll offset number are below:
1. Power up the receiver and transmitter.
2. From the receiver’s main menu screen, select Locate and click the trigger.
3. Toggle left one time, select Y for yes, and click the trigger.
Disabling the Set Roll Menu Option
If you are using a fixed housing that does not require the roll offset function, you should disable the Set
Roll option so that you do not accidentally change the roll by toggling right while in locate mode. To
disable the Set Roll option:
1. Power up the receiver
2. Toggle right to Configure and click the trigger
3. Toggle right several times to Unset Roll and click the trigger
Note that the menu option will change from Unset Roll to Set Roll.
28 DigiTrak
®
Eclipse
®
Operator’s Manual