User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Locating
58 DigiTrak
®
LT2™ Operator’s Manual
5. After finding the three locations to the side of the transmitter, P1, P2, and P3, connect these locations
with a line. This is the locate line. Because the LL runs perpendicular (or at a 90° angle) to the
transmitter, it is possible to determine the heading of the tool. By comparing the slant distances at the
predetermined distances of P1, P2, and P3, as the transmitter progresses you can verify if the tool is
moving away from or closer to the intended borepath. This allows steering corrections to be made.
LL
Obstruction
Path Around
Obstruction
Borepath
Drill
P2 P3P1
Off-Track Locating
3-1050-00-A