User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Locating
4. Release the trigger to see the depth display.
Height-Above-
Ground Setting
Replaces Telemetry
Channel Setting
T
ransmitter
Pitch Replaces
Temperature
Reading
Arrow pointing to tool
head indicates the
line is in the box and
the receiver is above
the transmitter or LL.
Depth Screen
NOTE: The arrow that appears below the depth measurement and that points to the transmitter
also appears on the remote display when the line is in the box.
5. Mark this location as the LL. You should now be standing above the transmitter.
Confirmation of Exact Heading and Transmitter Position
Like in the standard locating method, you can confirm the actual transmitter heading by locating the rear
locate point or RLP and then drawing a line between the RLP and FLP. That line represents the
transmitter heading. Where this line intersects the LL is the position of the transmitter.
Finding the RLP
1. While standing above the transmitter still facing the drill, hold in the trigger and continue walking
toward the drill; the signal strength will decrease and the target will appear in the top left corner of the
display.
Target in Top Left Corner
DigiTrak
®
LT2™ Operator’s Manual 55