User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Locating
3. Continue to walk forward until the "+" sign changes to a "–". Note that the target has moved into the
box and the signal strength has increased.
Target in the Box
4. Turn the receiver 90° from the transmitter heading while holding the receiver steady and level, and
again find the point where the "+" sign changes to a "–" by moving the receiver forward or backward
as needed; the target should be in the box. This is the FLP, which is where the transmitter will end up
if it does not get a steering command. Release the trigger.
5. Mark the location directly below the display screen as the FLP.
Finding the Transmitter and the LL
1. At the FLP, while continuing to hold in the trigger, turn again to face the drill head (and drill) and walk
forward toward the last locate point.
2. Note that the signal strength is negative and the value is increasing. The LL will appear in the top left
of the display.
3. Continue to walk forward until the "–" sign changes to a "+" sign. Note that the LL is centered in the
box.
LL Moving Toward the Box Line in the Box
54 DigiTrak
®
LT2™ Operator’s Manual