User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Locating
Drill
LL
FLP
RLP
Target in the Box at the RLP
3. Turn the receiver 90° from the transmitter heading while holding the receiver steady and level, and
again put the target in the box by moving the receiver forward or backward as needed.
Drill
LL
FLP
RLP
Target in the Box at the RLP Turn Receiver 90° and Move Back and
Forth to Center Target in Box at RLP
4. Mark this location as the RLP.
5. Connect the RLP to the FLP by a line. This line represents the actual transmitter heading.
NOTE: Both active and passive interference sources can affect the accuracy of the locate points
and depth readings.
52 DigiTrak
®
LT2™ Operator’s Manual