User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Locating
4. Turn the receiver 90° from the transmitter heading while holding the receiver steady and level, and
again center the target in the box by moving the receiver forward or backward as needed. This is the
FLP, which is where the transmitter will end up if it does not get a steering command.
5. Mark the location directly below the display screen as the FLP.
Drill
LL
FLP
RLP
Target in the Box at the FLP Turn Receiver 90° and Move Back and
Forth to Center Target in Box at FLP
NOTE: Both active and passive interference sources can affect the accuracy of the locate points
and depth readings.
DigiTrak
®
LT2™ Operator’s Manual 49