User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Locating
Finding the FLP
The first position to find is the front locate point or FLP. The FLP gives you the transmitter heading. The
FLP’s distance ahead of the transmitter is dependent upon the transmitter depth and pitch; the deeper it
is, the further in front the FLP will be. The FLP is represented as a target (
) on the receiver display.
Target in Top Left Corner
1. Stand out in front of the drill head (facing the drill) at a distance of approximately one drill rod length.
2. As you approach the FLP, the target appears in the top left corner of the display and the depth
number decreases.
3. Continue to walk forward until the target moves into the locating icon (box). You have found the
fore/aft position of the FLP; the next step will describe how to find the left/right position of the FLP.
Drill
LL
FLP
RLP
Target in the Box at the FLP Fore/Aft Position
48 DigiTrak
®
LT2™ Operator’s Manual