User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Locating
Marking Locate Points
The front and rear locate points (FLP and RLP) and the locate line (LL) must be found and accurately
marked during the locating procedure. To mark a locate position after you have found it, stand with the
receiver level directly above the locate point. Look down the vertical axis that runs through the center of
the display to project a plumb line to the ground. The point where this plumb line hits the ground is the
location that you should mark.
Plumb L
ine or
Vertical Axis
Center of
Display
Front of
Rec
eiver
Place Mar
ker
Straight Down
on Ground
Plumb Line for Marking Locate Points
HANDLING THE RECEIVER
NOTE: It is critical that you hold the receiver correctly to obtain accurate readings. You must hold the
receiver level at all times and maintain a constant height-above-ground distance that
matches the value it has been set to (see “Height Above Ground” menu discussion in the
Receiver section).
46 DigiTrak
®
LT2™ Operator’s Manual