User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Remote Display
Telemetry Channel Settings
The telemetry channel menu allows you to change the telemetry channel setting and is accessed by
clicking the button twice. With the telemetry channel menu displayed, as shown in the following picture,
hold the button in to cycle through the four channel options (1, 2, 3, 4), and release when the desired
setting is selected. You will hear three short confirmation beeps and see the channel number change on
the display.
Backlight On/Off
The backlight on/off menu option is accessed by clicking the button three times. At the backlight on/off
menu option, shown in the following picture, hold the function button in to turn the display backlight on or
off. The remote will emit a beep with the countdown sequence followed by three short confirmation beeps
when the menu item is successfully changed.
DigiTrak
®
LT2™ Operator’s Manual 37