User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Remote Display
By holding in the function button for 2 seconds or more, the transmitter temperature will display in place of
the pitch information and the telemetry channel will display in place of the height-above-ground setting, as
shown in the following figure.
Telemetry Channel Replaces
Height-Above-Ground Setting
Transmitter Temperature
Replaces Pitch Reading
Function Button Held In
Remote Display Menus
To access the remote display menus, click or press the function button. Each click advances you to the
next menu item. The function button on the remote works in the same manner as the trigger on the
receiver (see “Accessing and Changing Menu Settings” in the Receiver section).
Power Off
Click the button once to display the power off menu, as shown in the following picture. Hold the button in
for the countdown sequence from 3 to 0 to turn the unit off. Three short confirmation beeps will be heard
as the unit shuts down. The remote display will automatically shut itself off without an audible indicator if
no data is received for 15 minutes.
36 DigiTrak
®
LT2™ Operator’s Manual