User's Manual

Table Of Contents

Remote Display

Main Display Screen

The main remote display screen shows information sent from the receiver in a format very similar to the

display on the receiver. However, the battery status symbol displays the status of the remote display

battery rather than that of the receiver, as shown in the following drawing.

Main Remote Display Screen

The main display screen indicates when the receiver is over the transmitter or the locate line (LL) by

showing arrows above and below the depth value, as shown in the following figure. The receiver display

will show the line in the box.

Depth Reading When Receiver Is Above Transmitter or LL

In this display, the downward arrow is pointing to the transmitter to indicate that the reading is the actual

depth of the transmitter or LL. If there is not an arrow pointing down from the depth reading, then the

depth value shown indicates the slant distance (see Locating Instructions sect

ion).

NOTE: If you see four dashed lines ( — — — — ) where the distance/depth number should display,

then the receiver is too close to the transmitter and it is getting saturated with signal (see

“Height Above Ground” menu discussion in the Receiver section).

Height-

bove-

Ground Setting

Remote Display

Battery Status

eake

Distance to

Transmitter

Arrow pointing to tool

head indicates the line

is in the box and the

receiver is above the

transmitter or the LL.

Function

Button

Roll/Pitch Indicator

hould be flashing)

DigiTrak

LT2™ Operator’s Manual 35