User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
DIGITAL CONTROL INCORPORATED
Remote Display
A
ntenna
Speake
r
Thumb Screw
Mounting
Bracket
Func
tion
Button
Battery
Compartment
Display Window
Thumb Screw
DigiTrak LT2 Remote Display
General Description
The DigiTrak LT2 remote display, which is located at the drill rig, receives signals from the LT2 receiver
and displays that information on the remote display window. The remote comes with an antenna that
must be attached before drilling. The speaker to the left of the display window emits audible tones to
accompany menu changes and to warn the operator if the transmitter temperature is increasing.
To meet global requirements and for proper communication; the frequency designation shown on the
remote display’s serial number label (see figure below) must match that shown on the receiver. To
determine the receiver’s frequency designation, see the figure showing the receiver back label in the
“Turning On the Receiver” discussion in the Receiver section.
Te
lemetry Frequency
Designation
Serial Numbe
r
Back of Remote Display Showing
Serial Number and Telemetry Frequency Designation
DigiT
rak
®
LT2™ Operator’s Manual 33