User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
26 DigiTrak
®
LT2™ Operator’s Manual
PITCH UNITS
This display menu allows you to set the LT2 system to display pitch values in either degrees or percent of
slope.
1. Click the trigger to advance to the pitch units menu. The display will indicate the current setting.
2. Hold the trigger in through the countdown/beep sequence from 3 to 0.
Pitch Units Display Menu
3. When the counter reaches 0, you will see the unit setting change and a checkmark appear at the bot-
tom of the display accompanied by four confirmation beeps.
4. Release the trigger, and the display will automatically return to the locating screen.