User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
DEPTH UNITS
This display menu allows you to set the LT2 system to display values (depth and temperature) in either
English units (FT
IN
or “in” and °F) or metric units (M
CM
and °C).
1. Click the trigger to advance to the depth units menu. The display will indicate the current setting.
2. Hold the trigger in through the countdown/beep sequence from 3 to 0.
Depth Units Display Menu
3. When the counter reaches 0, you will see the unit setting change and a checkmark appear at the bot-
tom of the display accompanied by four confirmation beeps. If the desired units are not displayed
after the check mark appears, continue to hold the trigger in through the next count down sequence.
4. Release the trigger when the desired units are displayed. The display will then automatically return to
the locating screen.
NOTE: If you change the depth units between English and metric, the height-above-ground
setting will revert to the default value.
DigiTrak
®
LT2™ Operator’s Manual 25