User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
3. When the counter reaches 0, you will see a checkmark at the bottom of the display accompanied by
four short confirmation beeps.
4. While still holding the trigger in, the channel setting will cycle through all five settings—Off, 1, 2, 3, 4.
You will hear four short beeps each time the setting changes.
5. Release the trigger when the correct setting is displayed, and the display will then automatically
return to the locating screen. To confirm, hold in the trigger for 2 seconds or more to display the
channel setting.
BACKLIGHT
This display menu allows you to turn on or off the display backlight.
1. Click the trigger to advance to the backlight menu; a light bulb will appear on the display. If the
backlight is on, the bulb will be lit up; if it is off, the bulb will appear unlit.
2. Hold the trigger in through the countdown/beep sequence from 2 to 0.
Backlight Is Turned Off Backlight Is Turned On
3. Release the trigger when the counter reaches 0. The light bulb will either light up as the backlight
comes on or become unlit as the backlight turns off, and you will hear four short confirmation beeps
before the display automatically returns to the locating screen.
NOTE: The backlight automatically comes on for a few seconds at startup, and then it defaults to
the off setting, even if you have set it previously.
22 DigiTrak
®
LT2™ Operator’s Manual