User's Manual

Receiver
3. Continue to hold the trigger in through the countdown/beep sequence from 2 to 0.
4. Release the trigger when the 0 is displayed, and a checkmark will briefly appear at the bottom of the
display accompanied by three short confirmation beeps indicating this option has been selected. The
height-above-ground function has now been turned off, and the display will return to the locating
screen. With the height-above-ground function off, you must place the receiver on the ground for ac-
curate depth readings.
To set or change the height-above-ground measurement:
1. Hold the LT2 receiver at the height which you intend to hold the receiver.
2. Using a measuring tape, measure the distance from the bottom of the receiver to the ground. This is
your desired height-above-ground measurement.
3. From the locating screen, click the trigger to advance to the height-above-ground menu. You will see
the “On” option displayed.
4. Continue to hold the trigger in through the countdown/beep sequence from 2 to 0, and you will then
see the “Off” option displayed.
5. Continue to hold the trigger in through the countdown/beep sequence from 2 to 0, and you will see
the “Set” option displayed.
Height-Above-Ground “Set” Screen
6. Continue to hold the trigger in through the countdown/beep sequence from 2 to 0.
7. Continue to hold the trigger in, and the height-above-ground measurement will display starting at 12
in. (30 cm) and then counting up in 1-inch (2-cm) increments.
8. Once you see the desired height, according to the measurement you made in step 2, release the
trigger, and a checkmark will appear at the bottom of the display accompanied by three short confir-
mation beeps indicating you have reset the height-above-ground value. The display will then auto-
matically return to the locating screen with the height-above-ground function on.
20 DigiTrak
®
LT2™ Operator’s Manual