User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
Receiver Display Menus
The front label on the LT2 receiver shows the display menus (see figure below). This section describes
each menu function and gives instructions for how to change the menu settings. The menus are listed in
the order that they appear on the front label of the receiver, starting with the height-above-ground menu.
The locating mode is the standard default display that you will see when you turn on the receiver.
Receiver Display Menus as Shown on Front Label
HEIGHT ABOVE GROUND
This display menu allows you to enter a height-above-ground measurement so that you can measure the
transmitter depth without having to place the LT2 receiver on the ground. If the height-above-ground
function is not on, then you must place the receiver on the ground to take depth measurements.
The height-above-ground value can be set from a distance of 1
00
up to 3
00
using FT
IN
depth units (feet
and inches); from 12 up to 36 using “in” depth units (or inches only); or from 0
30
up to 0
90
using M
CM
depth
units (meters and centimeters)—see discussion of depth units menu later in this section.
DigiTrak
®
LT2™ Operator’s Manual 17