User's Manual

Receiver
Proper Handling of Receiver
Level Receiver Not Level Receiver
The receiver must always be held correctly to obtain
a
ccurate readings. You must hold the receiver level
at all times and at a constant height above the
ground (see “Height Above Ground” menu dis-
cussion later in this section).
You can track the transmitter by holding the receiver while facing the drill or while facing away from the
drill (see figures below). Either way, the information on the receiver display will be the same when at the
same location. For an accurate depth reading, you must hold the receiver level and have it aligned with
and directly above the transmitter.
Drill
Receiver
Transmitter
Drill
Receiver
Transmitter
Receiver Facing Away from Drill Receiver Facing Toward Drill
Accessing and Changing Menu Settings
To access the LT2 menu functions, you simply click the trigger. Each trigger click advances you to the
next menu item. When you stop at a menu, you will see a number that indicates a countdown sequence.
To change a menu setting, hold the trigger in while the counter goes down to 0; you will hear a beep
each time the counter decreases. Once the counter reaches 0, release the trigger and the menu setting
will be changed, which is indicated by a checkmark at the bottom of the screen (

) and a few short
confirmation beeps. If no trigger action is detected within 3 seconds, the display will return to the locating
mode screen.
16 DigiTrak
®
LT2™ Operator’s Manual