User's Manual

Receiver
Turning On the Receiver
To turn the LT2 receiver on, pull and hold the trigger in for 2 seconds and release. When the trigger is
engaged at startup, you will hear a short beep followed by a long tone. You will briefly see a series of
three screens at startup, before the default locating screen appears. The first startup screen shows all of
the display symbols illuminated. The second screen shows the firmware and software versions. The third
and final screen (shown in the following figure) displays the global designation number, which must match
that of the transmitter (see “Types of LT2 Transmitters” in the Transmitter section).
|
Global Designation
Number
Startup Screen Showing Global Designation Number
Turning Off the Receiver
To turn the unit off, you must first access the menu choices (see “Receiver Display Menus”). Click the
trigger until you reach the power menu
, then hold the trigger in during the countdown from 3 to 0 to
shut the receiver off; you will hear a beep each time the counter decreases followed by three short
confirmation beeps before the unit shuts off.
Note that when the receiver power is turned off, the height-above-ground function is also turned off. If you
want to use the height-above-ground function, you must turn it on and reset the value (if needed) after
you turn on the receiver.
Automatic Shutoff
The receiver will automatically shut itself off if no signal is received for 15 minutes.
As noted above, when the receiver power is turned off, the height-above-ground function is also turned
off. If you want to use the height-above-ground function, you must turn it on and reset the value (if
needed) after you turn on the receiver.
DigiTrak
®
LT2™ Operator’s Manual 13