User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
To meet global requirements and for proper communication; the frequency designation shown on the
receiver’s serial number label (see figure below) must match that shown on the remote display. To
determine the remote display’s frequency designation, see the figure showing the remote’s serial number
label in the “General Description” discussion in the Remote Display section.
Battery
Compartment
Cover
Thumb
Scre
ws
Te
lemetry
Frequency
Designation
Serial Numbe
r
Back of Receiver Showing
Serial Number and Telemetry Frequency Designation
Power On/Off
Installing the Battery Pack
1. Remove the battery compartment cover from the back of the receiver by rotating the thumb screws
counterclockwise.
2. Insert a fully charged battery pack terminal end first with exposed terminals aligned with springs in
battery compartment.
3. Replace the battery compartment cover and tighten the thumb screws by rotating them clockwise.
The serial number label on the back of the receiver shows the telemetry frequency designation (see
above photo). This frequency designation must match the frequency designation on the remote display,
which is located on the serial number label on the back of the remote display (see “General Description”
in the Remote Display section).
12 DigiTrak
®
LT2™ Operator’s Manual