User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating Instructions
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Introduction
10 DigiTrak
®
LT2™ Operator’s Manual
The LT2 system is programmed to comply with global operating requirements. The receiver’s global
designation number must match that of the transmitter for proper communication (see figure showing
startup screen under “General Description” in the Receiver se
ction and “Types of LT2 Transmitters” in the
Transmitter section
). Also, the receiver’s telemetry frequency designation must match that of the remote
display (see figure showing receiver back label in “General Description” in the Receiver se
ction and
“General Description” in the Remote Display section).