User's Manual

Introduction
8 Vermeer
®
DigiTrak
®
L
T
™
Operator’s Manual
Power Requirements
Device Voltage Current
DigiTrak LT Receiver 14.4 V DC (nominal) < 0.4 A DC
DigiTrak LT Remote Display 14.4 V DC (nominal) < 0.4 A DC
DigiTrak LT Battery Charger
12–28 V DC
100–240 V AC, 50/60 Hz
< 2.0 A DC
Environmental Requirements
Altitude < 16,404 ft (< 5000 m)
Temperature -4°F to 140°F (-20°C to 60°C)
Relative Humidity < 90%
Equipment Maintenance
¾ Turn off all equipment when not in use.
¾ Store the LT equipment in cases, away from heat, cold, and moisture. Perform tests to confirm
proper operations.
¾ Clean the LT receiver, remote, and battery charger by using a soft, moist cloth and Formula 409
®
All Purpose Cleaner (made by The Clorox Company) or a similar cleaning solution.
¾ Do not use chemicals to clean the transmitter.
¾ Clean the LCD screens on the receiver and remote display using a soft cloth without chemicals.
Use plain water if necessary.
¾ Inspect the LT equipment daily and contact DCI if you see any damage or problems. Do not dis-
assemble or attempt to repair the equipment.
¾ Do not ship the LT locating equipment with batteries inside. Always remove the batteries from the
equipment before shipping.