User's Manual

Locating
Vermeer
®
DigiTrak
®
L
T
™
Operator’s Manual 35
Marking Locate Points
The front and rear locate points (FLP and RLP) and the locate line (LL) must be found and accurately
marked during the locating procedure. To mark a locate position after you have found it, stand with the
receiver level directly above the locate point. Look down the vertical
axis that runs through the center of
the display to project a plumb line to the ground. The point where this plumb line hits the ground is the
location that you should mark.
Plumb Line for Marking Locate Points
HANDLING THE RECEIVER
NOTE: It is critical that you hold the receiver correctly to obtain accurate readings. You must hold
the receiver level at all times and maintain a constant height-above-ground distance.
Center o
f
Display
Vertical Axis
Place Marke
r
Straight Down
on Ground
Front o
f
Receiver
Plumb Line o
r