User's Manual

Battery Charger
32 Vermeer
®
DigiTrak
®
L
T
™
Operator’s Manual
No standard off-the-shelf battery will physically fit in the battery charger, and no nonrechargeable
batteries are provided in that physical format.
NOTE: Charge only DCI NiCad batteries in the battery charger. Charging or using other types of
batteries may damage the charger, the receiver, or the remote display and will void the
warranty.
To charge a battery, place the battery into the charger with the terminal end making contact with the
springs. The red light on the left will illuminate, indicating that the unit is charging (see figure below).
Battery Charger Control Panel
The battery will take between 2 to 3 hours to charge. When the charging cycle has been completed, the
green light on the right will illuminate.
NOTE: If a battery is left in the charger during a power interruption, the red or green light may
flash and the battery will begin to discharge on its own. After the power has resumed,
simply remove and replace the battery pack and press the desired charge or discharge
(condition) button.
Red Light:
- Solid indicates unit
is charging
- Blinking indicates
no incoming power
or charger failure
Green Light:
- Solid indicates
battery is fully
charged
- Blinking indicates
battery is being
conditioned
Charge
Button
Serial Numbe
r
Condition
Button