User's Manual

Remote Display
30 Vermeer
®
DigiTrak
®
L
T
™
Operator’s Manual
Depth Units
The depth units menu, shown in the picture below, allows you to set the remote display to show values
(depth and temperature) in either English (FT
IN
for feet/inches or “in” for inches only and °F) or metric
(M
CM
for meters/centimeters and °C) units. Hold the on/off button in to see the current unit setting; to
change the setting, hold the button in for the countdown sequence from 3 to 0.
NOTE: The depth units can be set on both the remote display and the receiver.
It is recommended
that the remote display and the receiver be set to the same depth units.
Pitch Units
The pitch units display menu, shown below, allows you to set the LT system to display pitch values in
either degrees or percent of slope. Hold the on/off button in to see the current unit setting; to change the
setting, hold the button in for the countdown sequence from 3 to 0.
NOTE: The pitch units can be set on both the remote display and the receiver. It is recommended
that the remote display and the receiver be set to the same pitch units.