User's Manual

Table Of Contents

Remote Display

28 Vermeer

DigiTrak

™

Operator’s Manual

The main display screen indicates when the receiver is over the transmitter or the locate line (LL) by

showing arrows above and below the depth value, as shown below. The receiver display will show the

line in the box.

Depth Reading When Receiver Is Above Transmitter or LL

In this display, the downward arrow is pointing to the transmitter to indicate that the reading is the actual

depth of the transmitter or LL. If there is not an arrow pointing down from the depth reading, then the

depth value shown indicates the slant distance (see Locating Instructions section).

NOTE: If you see four dashed lines ( — — — — ) where the distance/depth number should display,

then the receiver is too close to the transmitter and it is getting saturated with signal (see

“Height Above Ground” menu discussion in the Receiver section).

By holding in the on/off button for 2 seconds or more, the transmitter temperature will display in place of

the pitch information and the telemetry channel will display in place of the height-above-ground setting, as

shown below.

On/Off Button Held In

Arrow pointing to tool

head indicates the line

is in the box and the

receiver is above the

transmitter or the LL.

Telemetry Channel Replaces

Height-Above-Ground Setting

Transmitter Temperature

Replaces Pitch Reading