User's Manual

Transmitter
24 Vermeer
®
DigiTrak
®
L
T
™
Operator’s Manual
Transmitter Housing Requirements
To achieve maximum range and battery life for all of DCI’s transmitters, the slots in the housing must be
long enough and correctly positioned. Slot measurements should always be taken from the inside of the
housing. DCI recommends at least three slots equally spaced around the circumference of the housing.
The slots should be at least 1/16 or 0.0625 in. (1.6 mm) wide.
For the long-range LX transmitter (15 in./38 cm long), each slot should begin at least 2.0 in. (51 mm) from
the front of the transmitter and must be at least 8.5 in. (216 mm) long (see figure below).
Front
End
Back
End
8.5 in.
216 mm
2.0 in.
51 mm
Slot Position
Long-Range LX Transmitter Housing Slot Requirements
For the short-range LS transmitter (8 in./20 cm long), each slot should begin at least 1.25 in. (32 mm)
from the front of the transmitter and must be at least 3.75 in. (95 mm) long (see figure below).
Front
End
Back
End
3.75 in.
95 mm
1.25 in.
32 mm
Slot Position
Short-Range LS Transmitter Housing Slot Requirements
DCI offers an adapter so you can run the short-range LS transmitter in a standard-sized housing.
Mini Transmitter Adapter