User's Manual

Receiver
Vermeer
®
DigiTrak
®
L
T
™
Operator’s Manual 17
6. Continue to hold the trigger in through the countdown sequence from 2 to 0.
7. Continue to hold the trigger in, and the height-above-ground measurement will display starting at 12
in. (30 cm) and then counting up in 1-inch (2-cm) increments.
8. Once you see the desired height, according to the measurement you made in step 2, release the
trigger, and a checkmark will appear at the bottom of the screen indicating you have reset the height-
above-ground value. You will then be returned to the locating screen.
POWER
This display menu allows you to turn off the receiver.
1. Click the trigger to advance to the power menu.
2. Hold the trigger in through the countdown sequence from 3 to 0.
Power Off Screen
3. When the counter reaches 0, you will see a checkmark at the bottom of the display.
4. Release the trigger and the unit will shut off.
TELEMETRY
This display menu allows you to change the telemetry channel setting. This is the channel that the
receiver uses to communicate with the remote display. The receiver and the remote display must be set
to the same channel. There are eight different telemetry channels (1, 2, 3, 4, 5, 6, 7, 8).
1. Click the trigger to advance to the telemetry menu, where the current channel setting is displayed.
2. Hold the trigger in through the countdown sequence from 1 to 0.