User's Manual

Receiver
Vermeer
®
DigiTrak
®
L
T
™
Operator’s Manual 15
There are three options in the height-above-ground menu:
¾ “On” turns on the height-above-ground function and sets it to the last value that was used.
¾ “Off” turns off the height-above-ground function.
¾ “Set” allows you to set or change the height-above-ground value.
When you enter the height-above-ground menu, the “On” option is the first of the three settings for the
height-above-ground function.
To turn on the height-above-ground function:
1. From the locating screen, click the trigger to advance to the height-above-ground menu. You will see
the “On” option displayed as the first setting option. You will also see the last height-above-ground
number that was entered. If you want that number to remain the same, follow these instructions to
turn on the height-above-ground function. If you want to change this number, you must follow the
instructions to set or change the height-above-ground value, described later in this section.
Height-Above-Ground “On” Screen
2. Hold the trigger in through the countdown sequence from 2 to 0.
3. Release the trigger when the 0 is displayed, and a checkmark will briefly appear at the bottom of the
screen indicating this option has been selected. You have now turned on the height-above-ground
function; note that this value is the number that was last programmed. If you want to change this
number, see the instructions below “To set or change the height-above-ground measurement.”
4. Release the trigger, and you will be returned to the locating screen.
To turn off the height-above-ground function:
1. From the locating screen, click the trigger to advance to the height-above-ground menu. You will see
the “On” option displayed.
2. Continue to hold the trigger in through the countdown from 2 to 0, and you will then see the “Off”
option displayed.