User's Manual

Receiver
Vermeer
®
DigiTrak
®
L
T
™
Operator’s Manual 13
Accessing and Changing Menu Settings
To access the LT menu functions, you simply click the trigger. Each trigger click advances you to the
next menu item. When you stop at a menu, you will see a number that indicates a countdown sequence.
To change a menu setting, you hold the trigger in while the counter goes down to 0. Once the counter
reaches 0, release the trigger and the menu setting will be changed, which is indicated by a checkmark at
the bottom of the screen (
9
). If the change was not successful, you will see a checkmark with a slash
through it (
). The display will then go back to the standard locating display screen.
When in the standard locating mode, you hold the trigger in to display the signal strength in place of the
depth reading and the transmitter temperature in place of the pitch value. You will also see the telemetry
channel setting in the location where the height-above-ground value is normally shown. When using the
standard locating method, you leave the trigger out and move the receiver to position the target or line
symbol in the box. You can use the standard method of finding the locate points and locate line to find the
transmitter, or you can use the plus/minus ("+/–") locating method, which requires you to hold the trigger in
to locate the transmitter (see Locating Instructions section).
Receiver Display Menus
The front label on the LT receiver shows the display menus (see figure below). This section describes
each menu function and gives instructions for how to change the menu settings. The menus are listed in
the order that they appear on the front label of the receiver, starting with the height-above-ground menu.
The locating mode is the standard default display that you will see when you turn on the receiver.
HEIGHT ABOVE GROUND
On/Off/Set
Click trigger to sequence through menus; hold trigger through countdown to change receiv
e
settings. After setting change or trigger release, the receiver will return to the locating mod
e
®
Receiver Display Menus as Shown on Front Label