User's Manual

Receiver
10 Vermeer
®
DigiTrak
®
L
T
™
Operator’s Manual
Main Display Screen
When the LT receiver is on, the display screen usually shows the standard locating mode display (see
figure below), which is the default display. The display symbols that appear on the locating screen are
identified in the figure below and described in the “Standard Display Screen Symbols” table on the next
page. Note that the height-above-ground setting will only appear if the height-above-ground function is
enabled.
Standard Locating Mode Display with Height-Above-Ground Function
Enabled (Left) and Without (Right)
When the operator holds in the trigger, the display changes to show the telemetry channel setting, signal
strength, and transmitter temperature (see figure below and table on next page).
Standard Locating Mode Display with Trigger In
Signal Strength (with
+/– Locating Symbol)
Replaces Distance to
Transmitter
Transmitter
Temperature
Replaces Pitch
Reading
Height-
Above-
Ground
Setting
Target-in-
the-Box
®
Locating
Display
Distance to
Transmitter
Transmitter
Battery
Transmitter
Temperature
Transmitter
Roll (Clock)
Pitch/Roll
Update
Indicator
Transmitter
Pitch
Receiver
Battery
Telemetry Channel
Setting Replaces
Height-Above-
Ground Setting