User's Manual

DIGITAL CONTROL INCORPORATED
DigiTrak
®
F2™ Operator’s Manual 51
Battery Charger
General Description
F2 Battery Charger System
The DCI F Series Battery Charger (FBC) system includes AC and DC power cords, an AC adapter, and
three rechargeable lithium-ion battery packs. The battery packs are used to power the F2 receiver and
the FSD remote. Only DCI battery packs should be used in the F2 system and in the battery charger.
Using another type of battery could result in system damage and voiding of the warranty.
The battery charger can operate from AC (100–240 V, 50–60 Hz, 1.5 A max.) or DC (12 V, 5 A max.)
power sources, and power cords are provided for both power sources. The AC power cord that is shipped
with your system is standard to your global area of operation.
A fully charged DCI lithium-ion battery pack will power an F2
receiver for approximately 12 hours or an FSD remote for approxi-
mately 14 hours before recharging is necessary. The battery pack
can be recharged approximately 400 times before the battery life is
reduced by up to 50%.
To check the charge status of the DCI lithium-ion battery pack at any
time, press the battery status button below the five LEDs on the
battery. Each of the LEDs represents 20% of the battery charge.
While charging, the LEDs will flash to show the current charge level.
Upon completion of the charge cycle, all five LEDs will illuminate
briefly and then turn off.
AC Adapter
AC Power
Cord
DCI Lithium-Ion
Battery Charger
DCI Lithium-Ion
Battery Packs
DC Power
Cord
DCI Lithium-Ion Battery Pack
Tab
LEDs
Indicate
Charge
Level
Battery
Status
Button