User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Transmitter
38 DigiTrak
®
F2™ Operator’s Manual
FXL Transmitter Housing Slot Requirements
Both the FX and FXL transmitters are 1.25 in. (3.175 cm) in diameter and must fit snugly into the housing.
It may be necessary to wrap the transmitter with tape or O-rings to prevent it from rattling in the housing.
For the FS transmitter (8.00 in./20.3 cm long), each slot should begin at least 1.25 in. (32 mm) from the
front or index cap end of the transmitter and must be at least 3.75 in. (95 mm) long (see figure below).
Battery
Compartment End
Index
Cap End
Slot Position
Slot Length
3.75 in. (95 mm)
1.25 in.
(32 mm)
FS Transmitter Housing Slot Requirements
The FS transmitter is 1.00 in. (2.54 cm) in diameter and must fit snuggly in the housing. It may be
necessary to wrap the transmitter with taper or O-rings and/or use a housing adapter for larger drill
housings. Contact DCI for more information.
Battery Compartment End
Slot Position
Slot Length
13 in. (33 cm)
2 in.
(5.1 cm)
Front End Cap