User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
28 DigiTrak
®
F2™ Operator’s Manual
Roll Offset Menu
Click the trigger to toggle between the two options. Hold the trigger when the desired option is
highlighted.
After the enable roll offset option is selected, the following screen will appear. Once this screen has been
accessed, you will have 8 seconds to click the trigger or you will be returned to the locate screen with no
change to the roll display.
Activate Roll Offset
The images at the bottom of the screen instruct you to rotate the drill head to 12 o’clock. Click the trigger
to activate the roll offset and automatically be returned to the locate screen. If you do not click the trigger
within 8 seconds, you will be returned to the locate screen with no change to the roll offset. Roll offset is
denoted by a hollow dot in place of the solid dot on the clock face and the letters “RO” next to the clock
on both the receiver and remote display.
Enable Roll Offset
(Shown Highlighted)
Disable Roll Offset
Transmitter Roll
Transmitter Housing
Shown at 12:00