User's Manual
Table Of Contents
- Safety Precautions and Warnings
- Dear Customer:
- Introduction
- Receiver
- Transmitter
- Remote Display
- Battery Charger
- Locating
- The Target Steering Function
- Appendix A: System Specifications and Maintenance Requirements
- Appendix B: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix C: Calculating Depth Based on Distance Between FLP and RLP
- LIMITED WARRANTY
Receiver
26 DigiTrak
®
F2™ Operator’s Manual
Units Menu
The units menu allows you to select the depth and pitch units as well as to set a roll offset when the 12
o’clock index of the drill head does not match that of the transmitter. When the units menu is selected, the
following screen will appear with the depth units option highlighted, as shown below.
Receiver Units Menu
Click the trigger to scroll between the depth units, pitch units, and roll offset options. Hold the trigger in
when the desired option is highlighted.
Depth Units Menu
The depth units menu displays four options: IN” represents the use of inches only;
FT’IN” represents the use of both feet and inches; M.CM represents the use of metric units (meters and
centimeters); and FT’ represents the use of decimal feet. An arrow points to the current setting, which is
feet and inches in the example shown below.
Depth Units Menu
Depth Units Menu
(Shown Highlighted)
Pitch Units Menu
Roll Offset Menu