User's Manual

Receiver
16 DigiTrak
®
F2™ Operator’s Manual
Adjusting Screen Contrast
Adjust the screen contrast by holding the trigger in with the receiver
held vertical and in locate mode. Release the trigger when the screen
contrast is adjusted to the desired level.
Main Menu
The main menu allows you to set the desired depth units, pitch units, and height-above-ground (HAG)
distance; to select telemetry options; to calibrate the receiver to the transmitter; to use the Target Steering
function; and to turn off the receiver. To access the main menu, click the trigger from the locate mode
screen. You will see six menu options, with the first one, the HAG option, highlighted for selection.
Receiver Main Menu Screen
The main menu screen also displays the receiver battery status and the current telemetry channel selec-
tion (channel 2 is shown in the example above). If the Target Steering menu has been programmed with
a target depth, you will see that number below the icon, as shown in the figure above. If the main menu is
accessed by accident, you can click through all the options to return to the locate mode screen or wait 5
seconds for the menu to time out and return to the locate mode screen.
The table below shows the options available on the main menu and provides a brief description of each.
These options are described more fully in the following discussion. To access a menu option, hold the
trigger in with the option highlighted.
Receiver Battery Status
(Shown 80% Full)
Telemetry Channel Menu
(Channel 2 Selected)
Units Menu
Target Steering Menu
Height-Above-Ground
(HAG) Menu
Power Off
Calibration Menu
Box around item
indicates it is high-
lighted for selection.
2'00"
Programmed Target Depth