User's Manual

®
DIGITAL CONTROL INCORPORATED
Operational Tests
Self-Test for Mark III Receivers
Mark III Receivers have the capability of completing a diagnostic self-test to confirm proper operation.
This test must be conducted without a transmitter and in an interference-free environment. The self-test
procedure is conducted at start-up by clicking the trigger in a specific sequence.
1. Place a fully charged DigiTrak battery into the re
ceiver and click the trigger once.
2. At the tone, quickly click the trigger 3 times (observe the number 3 in the bottom window). The test
tak
es approximately 15 seconds to complete.
3. If no problem is detected, the receiver will sound 3 tones, and turn
itself off.
4. If the receiver detects a problem, it will display an
error code in the top left window accompanied by 2
long tones.
5. An error code of “001” indicates high background no
ise; move to an interference-free area and con-
duct the self-test again.
For assistance with troubleshooting an error code call DCI.
Receiver Balance Check
If the receiver appears to be exhibiting a consistent left or right error, it is possible that the antennas in the
receiver are out of balance. It is also possible to find the transmitter further to the left or right if you use
only signal strength to locate the transmitter or if there is an interference source within proximity. The
transmitter’s location (depth and left/right position) should always be determined using the front and rear
negative locate points, not relying solely on peak signal.
Axis
Line
Plus (+)
Changes to
Minus (–)
Axis
Line
Plus (+)
Changes to
Minus (–)
Receiver Balance Test – Make
sure “+” changes to “–”
on same line coming from both directions.
To determine if the receiver’s
antenn
as are in balance, com-
plete the following test:
1. Place the transmitter on
the grou
nd and step out in
front (or behind) about 10
to 12 ft (3 to 3.7 m) away
and a little to the left or
right side of the axis line
that extends from both
ends of the transmitter, as
shown in the drawing.
2. Hold the receiver perpen-
dic
ular to the transmitter
with the trigger held in.
DigiTrak
®
Mark III Operator’s Manual 37