User's Manual
Table Of Contents
- Important Safety Instructions
- Getting Started
- Receiver
- Receiver Menus
- Locating Basics
- Advanced Locating
- Transmitter
- Appendix A: System Specifications
- Appendix B: Receiver Screen Symbols
- Appendix C: Projected Depth Versus Actual Depth and the Fore/Aft Offset
- Appendix D: Calculating Depth Based on Distance Between FLP and RLP
- Appendix E: Reference Tables
DIGITALCONTROLINCORPORATED
DigiTrak Falcon F5
®
Operator's Manual v
Table of Contents
Important Safety Instructions 1
General 1
Pre-Drilling Testing 2
Interference 2
Potential Interference Received 2
Potential Interference Generated 2
Battery Pack Storage 3
Equipment Maintenance 3
General Transmitter Care Instructions 3
Getting Started 5
Introduction 5
Using This Manual 6
Powering On 6
Receiver 7
Transmitter 7
Remote Display (Aurora) 7
Setup Summary 7
Run Frequency Optimizer 7
Assign Frequency Bands 8
Interference Check 8
Calibrate 8
Above Ground Range Check 9
Drill 9
Receiver 10
Overview 10
Toggle and Trigger Switches 10
Audible Tones 11
Startup Screen 11
Using the Keypad 12
Your Remote Display 12
Receiver Menus 13
Locate Mode 14
Power Off 14
Calibration and AGR 14
1-Point Calibration 15
In-Ground Calibration 16
View Calibration 17
Above Ground Range (AGR) 17
15 m Calibration (Optional) 18
Height-Above-Ground (HAG) 18
Turn HAG On 19
Settings 20
Depth Units Menu 20